Lowara Steel Industrial Water Supply Pump series CEA and CA

Purchasing Guide for Lowara Steel Industrial Water Supply Pump series CEA and CA

1. Lowara Steel Industrial and Water Supply Pumps series CEA and CA are extensively used at home and industry (covers home and industrial consumptions) . It should be noted that Series CAE is monobutterfly and series CA is double butterfly.
2. Type N indicates type of stainless steel pumps L316 which are capable to pumping of corrosives.
3. Lowara Industrial and Water Supply Pumps series CEA and CA are full-steel and are used as follows:

• Rising water pressure in industrial and construction systems
• Circulating the water in installations, heating and cooling consumptions
• Water supply and fire fighting booster pumps
• For potable water consumption and water treatment systems RO
• Producing monopump booster pumps in the form of monphase and triple phase variable round with Pumps series CEA and CA.

The above pumps are capable to perform permanently Selection diagram of Lowara steel industrial and Water Supply Pumps has been presented in the opposite figures for more study and exact selection of required pump. Diameter of flange, drift and suction of pump is not obligatorily equal to diameter of pipe suitable for connection, since diameter of suction and deliverability pipe should be considered in such a way that maximum water speed in suction pipe of pump does exceed 2 M./second. and approximate selection diagram of water supply systems pipes diameter are shown in the opposite figures to be used by the experts. All Lowara pumps are subcategory of Zailem and are provided with 1-year warranty.

The points should be taken into consideration after purchasing Alfa Laval Plate Heat Exchangers

1. After installing pump and chassis on rubber or metal vibration absorbers installed on the foundation, remember that pump and chassis should be completely straightened so that we are sure of slow and vibration less performance of pumps during performance and operation period
2. Control pipes weights by sufficient supports and be careful that ground pump is not pressurized as the support of piping system pipes weight
3. If height of water drift in centrifugal water supply ground pumps is more than 15 m. and or the route is remarkably long, it is necessary to install non-return valve between pump and outlet valve to prevent from water hammering while turning off the pump and you are also recommended to install a gate valve in this route to regulate pump service point and prevent from its excessive absorption capacity
4. To cause the pump operates properly, a filter should be installed in the route of intake pipe and the intake route pipe should be executed absolutely without water seepage and with ramp in direction of pump (without air compression in higher alignment of pump inlet).